Hello,
I'm currently building my first machine and am running across some issues with what I believe to be the firmware.
I finished the mechanical build and have the whole thing wired up. I am using RAMPS 1.4, Marlin and Pronterface. I ran this test code on the board and the printer seemed to function properly:
Test Code
However, when I upload the marlin code and try to connect from pronterface, there is no response from the printer, although a green LED on the RAMPS board does light up.
Does anyone have some insight as to what I may be doing wrong (I assume its me, not a software/hardware issue)?
Thanks!
