Adding build status on LCD while printing from host November 12, 2012 05:53AM |
Registered: 11 years ago Posts: 38 |
Re: Adding build status on LCD while printing from host November 12, 2012 07:14AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Adding build status on LCD while printing from host November 12, 2012 07:21AM |
Registered: 11 years ago Posts: 38 |
Re: Adding build status on LCD while printing from host November 13, 2012 08:01AM |
Registered: 13 years ago Posts: 7,616 |
Quote
The problem with just sending a generic message is that the host needs to continually refresh that message (down the fully utilized serial link for most Arduino based controllers) in order to update it.
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Adding build status on LCD while printing from host November 16, 2012 05:30PM |
Registered: 11 years ago Posts: 38 |
Re: Adding build status on LCD while printing from host November 18, 2012 05:47AM |
Registered: 11 years ago Posts: 38 |