Welcome! Log In Create A New Profile


This wall infill problem

Posted by bbriggstkd 
This wall infill problem
July 13, 2013 09:07AM
I'm using Marlin and am getting pretty good results except when an object has thin walls. I don't get good infill . I'm printing with 90% infill and have 10 solid layers set. If there is a wide solid surface, the infill is fine.

I think it has something to do with acceleration. I don't think the extruder has time to get up to speed on short runs. I've tried all kinds of acceleration setting but can't seem to get it fixed.

Any ideas?
Sorry, only registered users may post in this forum.

Click here to login