I have a Phoenix printer with a Rambo board and am using Marlin firmware. I recently upgraded Marlin to help with autoleveling and now when I turn on the power, my steppers are disabled. I need to keep power on at least to my Z motors because my X axis floats. When the motors are disabled, it is very easy for my X axis to go out of level. My old firmware kept power to the motors all the time. The new firmware does not. There must be some settings in the firmware that are different, but I can't figure it out. Any help would be greatly appreciated.

[github.com]

check these 3 lines are false, or just for Z as desisred.