Not sure if this is the best place to post this but here goes...
I have just modified my RepRap style 3D printer to CoreXZ and though the normal movements are fine, the Z homing and bed levelling doesn't work properly - the X carriage only moves upwards. Bed levelling was working fine before converting to CoreXZ. I am using the options in
configuration.h to enable these features in Marlin 1.1.0 RC2 as downloaded from github. I know CoreXZ is a recent addition to Marlin and that this release is not yet fully tested but wondered if anyone else had this problem and found a solution.
Thanks in advance.
Gina