Welcome! Log In Create A New Profile


Delta Homing Troubles

Posted by dnbvet 
Delta Homing Troubles
December 05, 2015 06:19AM
Hi Guys, I've just built my first printer. Rostock delta, Keyes. I think a mini G2. Im running the Marlin firmware manufacturer setup for it (Marlin V1 Sprinter/grbl mashup for gen6).
My problem is homing. All axis move in the right direction but the Y axis is slow and stops before hitting the end stop. A M119 confirms its not triggered but X&Z are. See attached configuration.h
Any help would be much appreciated.

Edited 1 time(s). Last edit at 12/05/2015 06:20AM by dnbvet.
Re: Delta Homing Troubles
December 06, 2015 07:18AM
All stepper drivers are calibrated to the same Vref?

I also find the max acceleration a bit to high. Try 5000mm/s² .
Sorry, only registered users may post in this forum.

Click here to login