I can't figure out why the filament is ejecting ALL THE WAY OUT of my bowden tube after a print finishes when i switched to the Duet/Dc42 firmware...
I thought it was these lines in the default "end gcode" for the cura slicer that repetier host uses:
;G91 ; Relative positioning
;{IF_EXT0}T0
;G92 E0 ; Reset extruder position
;{IF_EXT0}G1 E-1 ; Reduce filament pressure
;G92 E0 ; Reset extruder position
but as you can see i commented them out...and it still does it... very annoying.
Anyone have a clue why?
Ive checked the gcode files on the sdcard (from the github repo) but I don't see anything.
Edited 1 time(s). Last edit at 01/23/2016 10:01PM by thetazzbot.