Hi
Hope someone can help.
I have a CR10 S5 (500x500 bed) and working well. Decided recently to purchase the Creality 3D ABL probe which also works well.
The issue I have is:
When I use the firmware (HEX file) sent to me by Creality it auto steps through 9 points and then reports back the mesh in the gcode fine. Unfortunately they don't enable tiny z steps in their firmware so can adjust the z on the fly when printing.
If I use the marlin firmware (latest from the site) I have enabled the bilinear bed levelling and can adjust the matrix. however it always asks me to press the button after each probe. I also does not report back the bed mesh in gcode. I have tried commenting out the LCD bed levelling but no matter what I do it does not work.
Attached are my config h and adv files. Any help would be appreciated. Im almost there with it
Hope you can help me get it sorted