Welcome! Log In Create A New Profile

Info RepRapFirmware

Posted by Mauxx

Forum List Message List New Topic

Mauxx

Info RepRapFirmware
November 04, 2019 11:37AM

Registered: 6 years ago
Posts: 20

Hi to all!

Is it possible use RepRapFirmware on SKR V1.3 Board?

Reply Quote

MKSA

Re: Info RepRapFirmware
November 04, 2019 12:01PM

Registered: 7 years ago
Posts: 1,007

[reprap.org]

"A comical prototype doesn't mean a dumb idea is possible" (Thunderf00t)

Reply Quote

dc42

Re: Info RepRapFirmware
November 04, 2019 02:56PM

Registered: 11 years ago
Posts: 14,685

Yes, see the link posted by MKSA and the repository at [github.com].

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

Mauxx

Re: Info RepRapFirmware
November 04, 2019 03:12PM

Registered: 6 years ago
Posts: 20

Thank You!!!

Another question... how i can configure it for my scara arm?

Reply Quote

sdavi

Re: Info RepRapFirmware
November 04, 2019 06:44PM

Registered: 11 years ago
Posts: 341

The online documentation for RepRapFirmware has a page on configuring scara: [duet3d.dozuki.com]

Reply Quote

chivel

Re: Info RepRapFirmware
December 27, 2020 12:57PM

Registered: 4 years ago
Posts: 6

Dear Sirs
Please explain to me why in the Status section for the Delta printer at the HOME point, the head position X and Y coordinates are 0 and Z is 999.
May be problem in Firmware version?

Reply Quote

dc42

Re: Info RepRapFirmware
December 28, 2020 03:29AM

Registered: 11 years ago
Posts: 14,685

If you are using RepRapFirmware then the Z position when homed is set by the H parameter in the M665 command. See [duet3d.dozuki.com].

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

chivel

Re: Info RepRapFirmware
December 29, 2020 11:37AM

Registered: 4 years ago
Posts: 6

H parameter in M665 is the level of Z-probe , not Z coordinate in DElta printer. In Delta X,Y,Z -in home must be 0.
DC42. In config.g I set in M666 X=0 Y=0 Z=0. Why Z = 999?

Edited 1 time(s). Last edit at 12/30/2020 10:33AM by chivel.