Welcome! Log In Create A New Profile


LCD Garbage Display.

Posted by Jarhead 
LCD Garbage Display.
March 20, 2023 02:39PM
Yup, another one of these....

This one is driving me crazy.
I lost my arduino, replaced with a newly flashed one, same firmware as the last, and now my LCD shows junk.
It's not interference as far as I can tell. Shielded cable, not very long and if I flash with stock it works fine.
Once I make my changes and flash it goes nuts.
I've been through the config files over and over and can't come up with the cause.
So other than making one change and flashing, one change and flash etc, can anyone give some tips as to what changes can effect the LCD?
I can post files here if anyone will take a look at them.
Sorry, only registered users may post in this forum.

Click here to login