After trying to elimenate my problems with a gap between my holes and my infill
Forums.reprap.org I tried switching to Marlin firmware and pronterface. However I am getting rather frustated trying to calibrate it and I can't seem to find any guide or forum threads discussing the firmware setup.
I have gotten the filament calibrated right after lowering the steps_pr_mm by about half. my problem now is that my retract speed looks like it is too high so the motor is skipping steps, afterwards it is then extruding all the filament that it should have retracted leaving way to much filament.
My other problem is that z axis also seems to be moving to fast so it is also skipping steps.
All in all my prints end up as a blop on the heatplate but at least there are no gaps.