I'm (trying to) use Repetier Development release 0.81 for a Delta

Upon attempting to upload to RAMPS, the upload will start (according to tx/rx led), but then quickly halts and I get this error:
avrdude: stk500v2_ReceiveMessage(): timeout

I have tried other firmwares, and they upload fine to both of my RAMPS. I have also tried several versions of Arduino software, all with the same result: I can upload other firms to either of my boards, and Repetier cannot be uploaded to either board due to this error.

This is frustrating. This is not my first printer and far from my first time compiling with Arduino, but for some reason I cannot get Repetier firmware to upload.

I'm a little upset I seem to be the only one with this issue, as it seems to be pretty obvious it's something in Repetier causing the issue.


Any ideas anyone?

Further info: Linux64

Edited 2 time(s). Last edit at 03/22/2013 09:05PM by xclusive585.

oddly enough...

This issue has something to do with the USB on my "3d" desktop machine...

Using my laptop (which has the same Distro, same Arch, same kernel) Repetier uploaded to the board fine.


Strangest dang thing I've ever seen.


Ah well all good thanks!