Teacup is small and beautiful, but...

Just test compiled both Teacup and Marlin in Arduino and found that Teacup has a really small foot print: .hex file about 18K. My question is whether Teacup supports Delta Printers or is there any plan to do it?

I am tempted to test it on Atmega328 (I know, it doesn't have enough pins, but..) just for fun.

I just got teacup to compile for rambo, and 2560 chipset. it still needs pin assignments. after i test the motion, I'll try to implement delta motion, at least well enough that someone else can do it better.


[github.com]


it compiles but pin assignments have not been verified as of yet. it is a copy of the 1280.h and the gen7 config file, also error traping for cpu has been removed and needs to be replaced. give me some time.