Welcome! Log In Create A New Profile

Advanced

anyway of putting h-gantry firmware onto a DDLMV1 break out board

Posted by nobler 
Forum List Message List New Topic
nobler
anyway of putting h-gantry firmware onto a DDLMV1 break out board
June 01, 2014 08:47AM
[ddcnc.com]

have one of these mach 3 compatible usb breakout boards

is there a way of changing the firmware to run a h-gantry

thank you

could I somehow put marlin / spprinter on it?

need to run 5a drivers and nema 23's and mach3 but on a h-plot/bot corexy

thanks
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login