I was wondering if there was a way in Marlin to level a particular area of my printer based off of say the min and max of the print even if i had to send those values with a custom G code command or script when i start the print? I know how to set the parameters for the auto level in the firmware, but i didn't know if there was a way to send the area i want to level rather than the whole print bed.
Say I had a print bed of 500mm x 500mm and was only printing an object in the front left and would take up a print surface area of 100mm x 80mm, how would I go about auto leveling for that area or at most 100mm x 100mm. And if i were to print 1 object at a time, level area 1 print then level area 2 and print?
I am guessing I would have to add a custom Gcode command and send the minX, minY, maxX, & maxY (possibly the number of probe points as well or just have that as a preset)?