Polar Firmware
Posted by Mr.Flipper
|
Polar Firmware November 08, 2016 10:33AM |
Hey guys!
I just saw this awesome looking Polar 3D printer and I thought it would be a nice university project. I was wondering if there is any open source polar firmware available?
Also, if I want to modify the Marlin firmware code to add new formulas for polar trajectories, where should I start? I know there 10000+ lines of code and I'm not sure where to start.
Thanks for the help!
JF
I just saw this awesome looking Polar 3D printer and I thought it would be a nice university project. I was wondering if there is any open source polar firmware available?
Also, if I want to modify the Marlin firmware code to add new formulas for polar trajectories, where should I start? I know there 10000+ lines of code and I'm not sure where to start.
Thanks for the help!
JF
|
Re: Polar Firmware November 11, 2016 12:42PM |
Check out
Concept Forge
[forum.conceptforge.org]
Many printers there use polar?
There is a forum here
Polar Machines, SCARA, Robot Arms
[forums.reprap.org]
Concept Forge
[forum.conceptforge.org]
Many printers there use polar?
There is a forum here
Polar Machines, SCARA, Robot Arms
[forums.reprap.org]
|
Re: Polar Firmware November 11, 2016 08:23PM |
Thx cozmicray!
I found the R-360 firmware on github!
I found the R-360 firmware on github!
Sorry, only registered users may post in this forum.