Wron distance moves from Marlin 1.1 to Marlin 1.3
July 01, 2017 02:08PM
Hi all,

I have recently switched from Marlin 1.1 to Marlin 1.3 and I can not get my Delta to move correctly.
Problem: Moves double the amount specified. ex. Send command to move 10mm but the printer will move 20mm
Set up: Rostock mini, Board: Ramp 1.3 , Arduino mega
I know my steps per mm are set correctly because I am using the same number that I used in the old Marlin firmware.

Anybody knows why?
Sorry, only registered users may post in this forum.

Click here to login