Welcome! Log In Create A New Profile

Heated bed Mk2 with Gen3

Posted by sweaving

sweaving

Heated bed Mk2 with Gen3
June 24, 2012 03:18PM

Registered: 15 years ago
Posts: 60

I have been googling my eyes out looking for details of how to wire up a Mk2 Mendel heated bed to the old Gen 3 electronics, can it be done the same way as the Cupcake heated bed? all i have found so far is that people have upgraded their electronics. i do not want to do this as i have only just got my gen3 Mendel up and running, and printing some very nice parts!

Ant advice would be very welcome!

Thanks
Steve

Reply Quote

sweaving

Re: Heated bed Mk2 with Gen3
June 25, 2012 02:07PM

Registered: 15 years ago
Posts: 60

Anyone any ideas?..lol.

Reply Quote

sweaving

Re: Heated bed Mk2 with Gen3
June 25, 2012 03:13PM

Registered: 15 years ago
Posts: 60

sused it..lol, i need a relay...

Reply Quote

nophead

Re: Heated bed Mk2 with Gen3
June 25, 2012 03:57PM

Admin
Registered: 18 years ago
Posts: 7,881

This should work better as a mechanical relay will wear out. [reprap.org]

You will also need to make a thermistor input by connecting a resistor and capacitor to an analogue input pin.

[www.hydraraptor.blogspot.com]

Reply Quote

sweaving

Re: Heated bed Mk2 with Gen3
June 26, 2012 03:05AM

Registered: 15 years ago
Posts: 60

Cool, v good link..thanks nophead :0)

Reply Quote

rapatan

Re: Heated bed Mk2 with Gen3
October 04, 2012 05:10PM

Registered: 14 years ago
Posts: 68

Take a look at this [reprap.org] where control of the heated bed is done by the Gen3 extruder 2.2 controller.

Reply Quote

brnrd

Re: Heated bed Mk2 with Gen3
October 04, 2012 11:18PM

Registered: 14 years ago
Posts: 1,780

Yes. I did this before I got RAMPS and it worked fine. I would recommend a different MOSFET since those ones run really hot if you want to print ABS with a 12V power supply.