Reprap Prusa i3 Introduction February 17, 2017 11:59AM |
Registered: 7 years ago Posts: 2 |
Re: Reprap Prusa i3 Introduction February 17, 2017 04:11PM |
Registered: 7 years ago Posts: 759 |
Re: Reprap Prusa i3 Introduction February 20, 2017 09:48AM |
Registered: 7 years ago Posts: 2 |
Quote
obewan
It looks from the video , you aree trying to move the extruder while the hot end is still cold.
The firmware will not let the extruder motor run unless the hot end is heated to about 175 degrees 1st or you enable cold extrusion
Re: Reprap Prusa i3 Introduction February 21, 2017 08:15AM |
Registered: 9 years ago Posts: 20 |
Re: Reprap Prusa i3 Introduction March 11, 2017 07:33AM |
Registered: 7 years ago Posts: 3 |
Re: Reprap Prusa i3 Introduction December 05, 2017 12:14PM |
Registered: 6 years ago Posts: 22 |