Quote
joeg_9
I am trying to add a fan to my RAMPS 1.4 board but thus far have been unsuccessful in getting any readings from a multimeter off of the D09 port. I have been using the command M106 SXXX to send values to the port, but nothing is changing. I have already uncommented the pin for the fan (23), is there anything else I need to do to enable this port?
Thanks,
Joe
I would like to add a fan for my stepper drivers and found a setting for it in "Configuration_adv.h" line 66. There are additional settings for extruder fans just below this entry. By default, these values are off.
Hope this helps
Ken
