Prusa I3 with Printrboard Electronics
April 26, 2013 01:40PM
Hi All,

We're going to be upgrading our Prusa Mendel to the I3 version here in the near future. We're running Printrboard electronics & would like to keep using them w/ the new I3. Does anyone have any experience or tips they can offer for using the Printrboard with the I3? Thanks so much!
jcr
Re: Prusa I3 with Printrboard Electronics
May 01, 2013 10:29AM
Hi strtrkn,

Since an i3 is basicly the same cartesian robot as a mendel is, the printrboard will work just fine. You need to adjust the firmware configuration to match the i3 of course, but that's about it.
Sorry, only registered users may post in this forum.

Click here to login