hot end alluminium or brass , mk4 , prusa i3
Posted by momix
|
Re: hot end alluminium or brass , mk4 , prusa i3 October 15, 2013 05:58PM |
hi,
for 20 euro " without link" it could be a china clone in which case buy two
. Don't be cheap on the hotend its a/the most important part, my choice would combo J head. save a little more and grab the E3D hotend. then you be able to print with any filament,
have fun jinx
for 20 euro " without link" it could be a china clone in which case buy two
. Don't be cheap on the hotend its a/the most important part, my choice would combo J head. save a little more and grab the E3D hotend. then you be able to print with any filament, have fun jinx
Sorry, only registered users may post in this forum.