I assume it's a setting in Slic3r, but I recently made a hollow cube and put a marble inside. I noticed that my printer was printing the posts diagonally, see attempted diagram.
1________2
.
.
.
4_________3
It prints from 1 to 3 then 4 to 2 and repeat.
I noticed that I could have put the marble in much earlier, but because it was going diagonally it would have hit the marble, where if it was going 1,2,3,4 it would always work around the marble.
Hopefully this makes sense. So what causes it to print diagonally instead of in straight lines around the model?
Edited 1 time(s). Last edit at 11/19/2013 09:58PM by vetteguy112233.