Welcome! Log In Create A New Profile

Mendel Extruder Head Ribbon Cable

Posted by rusdp

rusdp

Mendel Extruder Head Ribbon Cable
April 05, 2010 12:05AM

Registered: 15 years ago
Posts: 18

Hey guys. This should be the last of thing I need to get. I am currently looking for the "200mm 4-way ribbon cable" for the Mendel Extruder head. Any places you know where I can get it in the US?

Also, will Kapton tape work for the heatshrink needed?

Thanks for all your help.

- rusdp

Reply Quote

rusdp

Re: Mendel Extruder Head Ribbon Cable
April 06, 2010 01:37AM

Registered: 15 years ago
Posts: 18

Any ideas then about this?

Reply Quote

rusdp

Re: Mendel Extruder Head Ribbon Cable
April 06, 2010 02:04AM

Registered: 15 years ago
Posts: 18

What would be useful to know at least is the gauge size of the ribbon cable.

Thanks.

-rusdp

Reply Quote

Wade

Re: Mendel Extruder Head Ribbon Cable
April 06, 2010 01:23PM

Registered: 16 years ago
Posts: 536

Hey, ribbon cable is pretty standard - it's 0.05" between the cables. If you find any dead PC's around, you could snag some off the hard drive cables, or just order some up from Digikey.

That said, pretty much any small wire will work for the extruder - no need to use ribbon cable.

Reply Quote

J-Dubs

Re: Mendel Extruder Head Ribbon Cable
April 11, 2010 11:25PM

Registered: 14 years ago
Posts: 33

buy some 9 or 10 conductor ribbon cable from All Electronics and cut off the conductors you don't need?

-J