Hey,
So,the pictures in the installation are sometimes wrong, and I'm unsure about them with respect to the opto endstop mountings.
I think I have the x-axis one right, with the opto sensor on the bottom pointing towards the rear of the device, and a bolt in the bottom hole, head at the rear of the Mendel, nut at the front.
The z axis one is pretty straightforward too, because of the picture (the CAD drawing has the board drawn differently/wrong.
But the y axis one baffles me. I think I installed the endstop correctly, but it barely reaches the endstop, and it's not clear how it's intended to be mounted. I don't trust the CAD drawing. I tried gleaming it from Adrian'a wiring video but can't quite make it out.
I know I can just cut an appropriate new thin sheet that's bigger, and I know I can figure out a working solution, but I'm curious how it was INTENDED that it mount.
Thanks.
--Jeff Keegan (
Just Another RepRap blog)