Hi,

Just bought a Prusa Mendel i2 kit. The kit contains a Budaschnozzle Hot end, does anybody have any instructions on how to connect the wires?

Regards,
Kev

The Budaschnozzle has two wires for the heating element - they'll be the thick ones - and two for the thermistor - they'll be the thinner ones. There is no polarity on either, but follow the colour guide if they're in red/black pairs.

How they are connected to your electronics board depends entirely on which board you have. Either post it here or google for " wiring diagram" - e.g. for the RAMPS board: [reprap.org]

---

[3DKarma.com] - suppliers of quality, affordable 3D printer kits and filament for the UK market.

Yeah, the two bigger wires should be connected to the hotend pins. It depends on what kind of board you use.

---

Everything of 3D printer. www.3dminions.com
[www.facebook.com]

Hi 3dKarma and Peterxm,

Thank you for your reply guys! Thank you for the link! That is exactly what I was looking for. The Ramp board I have is the Ramps 1.4. The Nozzle I have is only for a single extruder. I am so happy that I can see the wiring diagram from the link.

Thanks Guys!