Welcome! Log In Create A New Profile


Extruder: loose bearing and M4 insert

Posted by Ecir Hana 
Extruder: loose bearing and M4 insert
October 16, 2010 02:27PM

just to check if I understand it correctly - when I "[p]lace [the bearing] in the declavity in the idler holder" and put the M4 insert into opposite side - these two parts (rod and thread) stay there only if I put filament in-between. Is this correct? Because everytime I remove the filament the larger gear falls off. Shouldn't I glue those two parts so that they stay in-place?
Sorry, only registered users may post in this forum.

Click here to login