Welcome! Log In Create A New Profile

no disply

Posted by chris97

chris97

no disply
April 05, 2016 07:35PM

Registered: 8 years ago
Posts: 2

hi i just built a Sintron] 3D Printer Prusa i3 Reprap and when turn on i have no disply on my lcd it lights up..idnt have any leds lit up on ramps board i havw the software uploaded onto pc but dnt know what to do with after its unzips.i have andiuno 1,6,8 skecth open..

Reply Quote

Techytom

Re: no disply
April 10, 2016 02:05PM

Registered: 8 years ago
Posts: 5

Hi Chris,

Im pretty new to this but i have a possible answer - do you have a slot for an SD card on your printer? - if so try changing the leads over on the board for the LCD and the SD card - this may work.

Hope this helps

Kind Regards
Tom