material not coming out of nozzle June 24, 2016 05:33PM |
Registered: 8 years ago Posts: 2 |
Re: material not coming out of nozzle June 24, 2016 09:29PM |
Registered: 9 years ago Posts: 443 |
Re: material not coming out of nozzle June 25, 2016 04:15AM |
Registered: 8 years ago Posts: 622 |
Quote
zatix
Hello,
I just bought and mounted a cheap Ebay (you can see the specs at [www.ebay.co.uk])
The material does not come out of the nozzle, the engine that is supposed to push it is clicking and failing to do so. I tried different temperature settings, speeds.
I am pretty sure that the filament is getting into the nozzle properly, if I push it hard permanently in a little bit comes out but not enough I think.
I show below a picture.
Many thanks