Welcome! Log In Create A New Profile

M108 Rxx ???? Repg 25, SF40

comwarrior

M108 Rxx ???? Repg 25, SF40
December 19, 2011 11:23AM

Registered: 14 years ago
Posts: 23

I've been battling with a swissing issue for the last two days.
I've gone back to ye-old-faithfull repg25 and it was doing the same.

And now i've just noticed that all the extruder speed settings are 'M108 Rxx' and they should be 'M108 Sxx'

Can someone point me in the right direction for this one because as far as i'm aware, 'M108 R' is an invalid G-code and shouldn't have been programmed...

Thanks

Reply Quote

comwarrior

Re: M108 Rxx ???? Repg 25, SF40
December 19, 2011 01:11PM

Registered: 14 years ago
Posts: 23

it is doing the same in repg26 with SF40...

Reply Quote

comwarrior

Re: M108 Rxx ???? Repg 25, SF40
December 24, 2011 05:43PM

Registered: 14 years ago
Posts: 23

i have literally just found the cause to this... under speed tab, 'add flow rate' was ticked... it changes M108 S to M108 R... IE Speed to Rate...

This is not mentioned in the SF manual so, can someone please add it.
Thanks

edit:
Correction, this completely removes the speed setting. but still, needs to be added to the manual.

Edited 1 time(s). Last edit at 12/25/2011 07:32PM by comwarrior.