Prevent skeinforge from homing
Posted by dbenoy
|
Prevent skeinforge from homing February 22, 2012 08:04PM |
Is it possible to prevent skeinforge from going to the origin point when it starts up?
I made a startup gcode file that does a home, then a little extrusion purge and wipe before it starts, but then skeinforge makes it go home again
I'd rather it go directly to where it's going to lay the print.
Unchecking the 'Home' plugin wasn't enough.
I made a startup gcode file that does a home, then a little extrusion purge and wipe before it starts, but then skeinforge makes it go home again
I'd rather it go directly to where it's going to lay the print.Unchecking the 'Home' plugin wasn't enough.
|
Re: Prevent skeinforge from homing February 23, 2012 02:38AM |
Did you recreate the gcode file AFTER unchecking Home? 
Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse
Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse
Sorry, only registered users may post in this forum.