Hi,
I suspect I'm doing something stupid but can't work out what.
When I use Skeinforge to produce my Gcode it seems fine except there are no E 'movements'. So nothing is extruded. Everything else (e.g. X, Y & Z moves) looks OK.
Here's the start of the Gcode file that is produced:
G21
G90
G92 X25 Y0
@isathome
M113 S1.0
M108 S50.0
G1 X-12.52 Y10.404 Z0.2 F3000.0
M101
G1 X-10.404 Y12.52 Z0.2 F3000.0
G1 X10.404 Y12.52 Z0.2 F3000.0
G1 X12.52 Y10.404 Z0.2 F3000.0
G1 X12.52 Y-10.404 Z0.2 F3000.0
G1 X10.404 Y-12.52 Z0.2 F3000.0
G1 X-10.404 Y-12.52 Z0.2 F3000.0
G1 X-12.52 Y-10.404 Z0.2 F3000.0
G1 X-12.52 Y10.404 Z0.2 F3000.0
M103
G1 X-9.28 Y-9.64 Z0.2 F3000.0
M101
G1 X9.64 Y-9.64 Z0.2 F3000.0
G1 X9.64 Y9.64 Z0.2 F3000.0
G1 X-9.64 Y9.64 Z0.2 F3000.0
No E numbers
I tried the same slice in Slic3r and that seems OK. So, I assume it's one of my Skeinforge settings.
Any ideas???
Thanks
Pete