Welcome! Log In Create A New Profile

Advanced

(to delete - moved to skeinforge forum)

Posted by casainho 
Forum List Message List New Topic
casainho
(to delete - moved to skeinforge forum)
January 22, 2010 04:44PM
I made a mistake, I wanted to post about Skeinforge and is instead here:
[dev.forums.reprap.org]

Moderator, please delete this message.

Edited 1 time(s). Last edit at 01/22/2010 04:52PM by casainho.

---
New cutting edge RepRap electronics, ARM 32 bits @ 100MHz runs RepRap @ 725mm/s:

[www.3dprinting-r2c2.com]
Reply Quote
Tonokip
Re: Skeinforge question -- shells problem
January 22, 2010 05:03PM
Hi Casainho!

Try lowering the the Carve setting Perimeter width over Thickness (ratio).

smiling smiley
Reply Quote
Newer Topic Older Topic
Sorry, you can't reply to this topic. It has been closed.