Hi all,
I'm using the latest Skeinforge, but I've noticed that I'm getting weird results when doing independent Z moves. I'm using the trick to have a dummy homing.gcode file, but still, I get strange behavior:
G1 X-8.68 Y8.96 Z10.56 F1920.0 E0.31
G1 F2400.0
G1 E-6.5
G1 F1920.0
M103
G1 X-8.68 Y8.96 Z10.89 F30.0 <-- Correct feedrate set for doing an independent Z move
G1 X-8.77 Y8.49 Z10.89 F1920.0 <-- Correct feedrate, back to normal for doing extrusion
G1 X-8.85 Y8.07 Z10.89 F88.006 <-- What is this one?
G1 F2400.0 <-- Seems Back to normal after here
G1 E11.5
G1 F88.006 <-- This may just be a relic where it sets it back to the previous value
M101
G1 X-8.85 Y-8.85 Z10.89 F1920.0 E13.212 <-- All feedrates now good until next layer change.
This happens right after every Z move. My homing.gcode file is just "; dummy comment".
Any ideas? Thanks!
--Jake