Make outline start on inside of object

I have recently switched from using the RepRap java Host to skeinforge, I have managed to get quite good prints with it now but there are still some small blobs and sometimes gaps on the sides of the printed objects, how can I get skeinforge to... (like the java host does)... start the outlines on the inside of an object and head to the edge so that it 'Purges' the extruder before the outline is printed?

Any suggestions will be very handy, thanks.

Thread Sequence Choice in the Fill plugin.

And activate Skirt for 1 layer.

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Greg Frost Wrote:
-------------------------------------------------------
> Thread Sequence Choice in the Fill plugin.

To what should I set this option?

Loops > Perimeter > Infill

IF you don't want it to start on the outside.
I personally use Perimeter > Loops > Infill.

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

This option just seems to make it do things in a different order, how do I get the perimeter to start extruding inside the object and then go to the edge like the java host?

This is the difference:

AFAIK that is not currently possible using Skeinforge.

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Set for Loops->Perimeter->Infill as Bob suggested and turn on Clip with parameters 0.15 and 10 for the Clip over Extrusion Width (ratio) and the Maximum Connection Distance Over Perimeter Width (ratio). The explanation is here.