Software for DLP 3D printer

Hi everybody,

I a am french and new here.
Hope I post in the forum good category. If not, please excuse me.

I'm very interested to build my home DLP 3D printer.

Could you please help me about choosing a software to slice and drive pictures to DLP projector ?

I found Creation Work. Do you have others software to suggest me ?

Is there a folder dedicated to DLP 3D printer on this great RepRap forum ?

Thanks by advance !

Allmix

Edited 1 time(s). Last edit at 08/07/2014 03:37PM by Allmix.

AutoDesk is supposedly preparing to release opensource software for resin printers, and a printer.

Polymer Working Group
Plastics, Epoxies, Resins, Photopolymerization, etc - Research, Development, Use, and Analysis
[forums.reprap.org]

thank you for the information !

I just published a page about LCD based 3D printer.
This may interest some of you

There is a software name Flash point beta version which is quite good in terms of slicing ..
here is the link

[sedgwick3d.com]