SD card printing October 04, 2011 05:48PM |
Registered: 13 years ago Posts: 22 |
Re: SD card printing October 05, 2011 07:00AM |
Admin Registered: 13 years ago Posts: 2,569 |
Re: SD card printing October 06, 2011 12:10AM |
Registered: 13 years ago Posts: 57 |
SD card doesn't work October 10, 2011 08:58AM |
Registered: 14 years ago Posts: 89 |
Re: SD card doesn't work March 01, 2013 06:48AM |
Registered: 13 years ago Posts: 71 |
Re: SD card doesn't work June 01, 2014 07:30PM |
Registered: 12 years ago Posts: 142 |
Quote
fredted1234
Hi im tryin to use SD ramps, im enabled it in marlin. the software pronterface can pick up the sd card and read the file. when i click on the file it loads the file and starts printing. however when i press the disconnect or pull out the cable from the pc it stops printing. the led is on on the arduino when i plug out the usb and the D1 and D2 is installed on the ramps.
Does anyone know where im going wrong.
Im naming the files test.gco this is ok isnt it?
thanks