Welcome! Log In Create A New Profile

Sanguinolou / stepper-motors.

Posted by Dobert

Dobert

Sanguinolou / stepper-motors.
January 14, 2012 01:02PM

Registered: 14 years ago
Posts: 19

I'm a first time Prusa Mendel builder wishing to connect my Sanguinololu to my stepper-motors.

I hav a Nema-17 42BYGHW811 stepper-motors. Wiring: Black=A, Green=B, Red = C and Blue=D.

The Sanguinololu connections for the stepper motors are 2B, 2A, 1A and 1B.
Now I'm a little confused which wire goes where.
If anyone can give me a helping hand, I would be very grateful.

Edited 1 time(s). Last edit at 01/15/2012 06:54AM by Dobert.

Reply Quote

smartroad

Re: Sanguinolou / stepper-motors.
January 15, 2012 10:02AM

Registered: 15 years ago
Posts: 81

Replied in other topic, but will post here for others too

I have mine wired Green Black Red Blue with the green pointing towards the mosfets

Hope this helps!

Reply Quote

Dobert

Re: Sanguinolou / stepper-motors.
January 15, 2012 10:59AM

Registered: 14 years ago
Posts: 19

Thanks very much. I can now get on with the wiring in anticipation of an answer to my question in Forum>Software>Experimental “Problem with Ponterface printer interface”.

As you can see, I'm becoming a very enthusiastic 3-D builder (it's keeping me up at night), but I'm a novice to forums and have probably placed my question under the wrong heading.

Thanks again