Welcome! Log In Create A New Profile


S. 1,3a board & TB6560 motor driver?

Posted by codec 
S. 1,3a board & TB6560 motor driver?
January 16, 2012 02:07PM
I want to start build nu printer (bigger than typical mendel-prusa reprap) and need to use bigger motors. I want to use S. 1.3a board and custom drivers (2.5A minimum each motor). Is possible to use any ENA/STEP/DIR drivers (for bipolar motors) with this board?
Re: S. 1,3a board & TB6560 motor driver?
January 16, 2012 08:23PM
Yes, it is. AKA47 did some TB6560 drivers that are on separate boards here


I'm working on a TB6560 based gen7 variant, pre alpha version can be seen here


So if you want to interface with Sanguinololu specifically, the AKA47 boards are a good choice. Current version of Gen7T is not quite ready for prime time. Or if you are doing your own, good luck, and let us know what you end up with and how well it works.
Sorry, only registered users may post in this forum.

Click here to login