Welcome! Log In Create A New Profile

How to get Marlin file from Sanguinou

Posted by gnomadix

gnomadix

How to get Marlin file from Sanguinou
October 03, 2012 04:23AM

Registered: 12 years ago
Posts: 44

Hi all,

I would be grateful for some help: I want to get the Marlin file from my board

When running Avrdude in Dos where would the device path be found?
ie if /dev/tty is a unix location what would XP equivalent be

Can I find out the calibrated settings from the Hex file?

Many Thanks
SImon

Reply Quote

Traumflug

Re: How to get Marlin file from Sanguinou
October 04, 2012 06:26AM

Registered: 13 years ago
Posts: 7,616

Quote

When running Avrdude in Dos where would the device path be found?
ie if /dev/tty is a unix location what would XP equivalent be

COM1, COM5 or something like that, depending on what the OS assigns to the adapter.

Quote

Can I find out the calibrated settings from the Hex file?

No. At least not in a simple way. Uploading a firmware with known settings is much easier.

Generation 7 Electronics	Teacup Firmware	RepRap DIY

Reply Quote

jcabrer

Re: How to get Marlin file from Sanguinou
October 07, 2012 01:33AM

Registered: 17 years ago
Posts: 824

If your marlin firmware makes use of the EEPROM storage, you can read most of your calibration values from there. Repetier host has a readout in the configuration menu

Reply Quote

gnomadix

Re: How to get Marlin file from Sanguinou
October 07, 2012 03:09AM

Registered: 12 years ago
Posts: 44

Thanks for the replies Tramflaug and Jcaber
I'll take a look at the Repetier host

Thanks again