Welcome! Log In Create A New Profile


L298 bridge

Posted by fecapo 
L298 bridge
August 07, 2014 10:33PM
First, sorry for my english, i'm from argentina

my question is about a connect of a dual h bridge (l298).

can i connect like this image?

is for control 2 stepper motor (current : 2A each )
i want to connect 2 L298 drivers in parallel

here is the L298 datasheet

thanks a lot!
Re: L298 bridge
August 08, 2014 06:11AM
Watch out for Generation 2 Electronics in the wiki. It had stepper drivers using this chip.

Generation 7 Electronics Teacup Firmware RepRap DIY
Re: L298 bridge
August 08, 2014 12:12PM
i was looking for this IC.. but anyone tried to conect like the image..
everyone connect a L297 with the ramps.. but i cant find this ic near my house..
so i want to use the polulu driver like a L297...
Re: L298 bridge
August 08, 2014 04:02PM
No you can't connect it like that. You can't drive the input of an L298 with the output of a pololu.

Sorry, only registered users may post in this forum.

Click here to login