Engineering/Art Piece August 18, 2014 09:17AM |
Registered: 9 years ago Posts: 7 |
Re: Engineering/Art Piece August 19, 2014 06:10AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Engineering/Art Piece August 19, 2014 07:51PM |
Registered: 9 years ago Posts: 7 |
Re: Engineering/Art Piece August 20, 2014 03:29AM |
Registered: 9 years ago Posts: 7 |
Re: Engineering/Art Piece August 20, 2014 11:06AM |
Registered: 13 years ago Posts: 7,616 |
Quote
ColinPoly
What type of gcode sender should I use?
Quote
ColinPoly
I have 4 motors so does that mean I need a 4-axis compatible one?
Quote
ColinPoly
I have been dabbling around with senders, flashing my arduino, probably making a mess of things so any guidance would be perfect.
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Engineering/Art Piece August 20, 2014 07:02PM |
Registered: 9 years ago Posts: 7 |
Quote
Traumflug
Most simple case? A serial terminal, like PuTTY, CoolTerm, GtkTerm. Connect, type commands, watch what happens. Pronterface should also work. Repetier Host might do things you don't want (it tries to "help" printers).
Quote
Traumflug
About all RepRap firmwares and controllers _are_ 4 axes. 3 axes bot (X, Y, Z) and one extruder (E). An extruder ist just a stepper, too; heater & Co. are entirely independent.
Quote
Traumflug
1. I love feedback from non-technical people.
Re: Engineering/Art Piece August 23, 2014 07:50PM |
Registered: 9 years ago Posts: 7 |
Re: Engineering/Art Piece August 23, 2014 08:00PM |
Registered: 9 years ago Posts: 7 |
Re: Engineering/Art Piece August 24, 2014 01:07PM |
Registered: 9 years ago Posts: 7 |