Welcome! Log In Create A New Profile


Nema 17 motor wires

Posted by vhoward1122 
Nema 17 motor wires
May 03, 2015 09:48PM
I bought a sc42sth47-1648a 1.8 degree 2 phase motor to use with a different extruder setup. When I received the motor, there are 4 wires sticking out of the motor with no connector at the end. I received no wiring diagram for the motor. The wire colors are black, blue, green and red. I looked into the opening they come out of and the red and green come from the right and the blue and black come from the left to exit that opening.. Anyone around that could give me an educated guess or knows the order I should put them into a connector to plug onto a ramps 1.4 board?

Thanks, Vance.

Folger Tech Prussa I3
Arduino 2560 Mega
Ramps 1.4
A4988 stepper drivers
Repetier Host
Marlin firmware
Re: Nema 17 motor wires
May 03, 2015 11:11PM
Re: Nema 17 motor wires
May 04, 2015 07:18AM
The reprap wiki is worth a read.

Currently have a tweaked mendel prusa i2
About to build a P3Steel.

Printer for hire.

Member of South London Makerspace:
Re: Nema 17 motor wires
May 04, 2015 10:45AM
Thanks for the wiki link. Just did not want to damage the motor by putting wires in a random order.
Sorry, only registered users may post in this forum.

Click here to login