Welcome! Log In Create A New Profile

Advanced

Identifing a damaged stepper

Posted by Gaou 
Identifing a damaged stepper
June 02, 2016 12:57PM
Guys today i started a print but the extruder wasn't pushing filament. I touch it and it was too hot. It could retract but no matter what i did it couldn't extract . So is there anyway to tell for sure if the stepper is damaged ?


RePrapPro Mendel 3
Duet 0.8.5 firmware 1.19
Sorry, only registered users may post in this forum.

Click here to login