1 Stepper Motor, Uno R3, CNC, power supply question August 24, 2016 09:14PM |
Registered: 9 years ago Posts: 14 |
Re: 1 Stepper Motor, Uno R3, CNC, power supply question August 24, 2016 10:46PM |
Admin Registered: 13 years ago Posts: 7,000 |
Re: 1 Stepper Motor, Uno R3, CNC, power supply question August 25, 2016 10:47AM |
Registered: 9 years ago Posts: 14 |
Re: 1 Stepper Motor, Uno R3, CNC, power supply question August 25, 2016 04:24PM |
Registered: 11 years ago Posts: 1,049 |
Re: 1 Stepper Motor, Uno R3, CNC, power supply question August 26, 2016 05:11AM |
Admin Registered: 13 years ago Posts: 7,000 |
Re: 1 Stepper Motor, Uno R3, CNC, power supply question August 26, 2016 01:04PM |
Registered: 9 years ago Posts: 14 |
Quote
cozmicray
Once again
I am doing a project ---- here is no information but
I can't wire and know nothing --- please design and do project for me!!
It would be nice to know what your stepper is going to do?
Does it need a lot of power, high current?
What CNC shield?
The supplier of shield doesn't help at all?
Are you going to use a special firmware / software to run project?
GRBL --- is nice and simple
You could use an Arduino and an Easy Driver powered by 6 to 30V power supply?
Power arduino via USB and power motor, via driver,
with any 12 - 24 volt supply that delivers 2+ amps
[learn.sparkfun.com]
Quote
Dust
Quote
cozmicray
Once again
I am doing a project ---- here is no information but
I can't wire and know nothing --- please design and do project for me!!
angry smiley
Everyone has to start somewhere...
Re: 1 Stepper Motor, Uno R3, CNC, power supply question August 27, 2016 02:58PM |
Registered: 11 years ago Posts: 1,049 |
Re: 1 Stepper Motor, Uno R3, CNC, power supply question August 27, 2016 07:04PM |
Registered: 9 years ago Posts: 14 |
Quote
cozmicray
I guess I don't know what your "printer" is?
Does it have Three axes moved by stepper motors, controlled by a controller.
A "printer" with only a moveable Z axis? Is that really a printer?
X and Y moved by corvette engines on chains?
The board you got I call a GRBL board
one like it controls my CNC router X, Y and Z (spindle up down, or laser ON/OFF)
Via GRBL firmware
I use one driver on Arduino GRBL to drive Threadless Leadscrew tests
[www.youtube.com]
Without any or correct info --- one cannot supply help.
So can't help if I don't know "What it is" Photos?
Re: 1 Stepper Motor, Uno R3, CNC, power supply question August 27, 2016 11:28PM |
Registered: 11 years ago Posts: 1,049 |
Re: 1 Stepper Motor, Uno R3, CNC, power supply question August 30, 2016 07:29AM |
Registered: 13 years ago Posts: 1,352 |