Ok... Quick question hopefully I can figure out how to word this properly.
I have ramps, I want to use external drivers.
Both ramps and the external drivers have jumper settings for microsteps.
Which scenario is correct?
1. Ramps Jumpers set to full step, external driver set to 1/8th (what i want to run)
2. Ramps jumpers to 1/8 external 1/8.
3. Ramps no jumpers (open) and use external jumpers to set?
Then, Firmware. I'm assuming once I have my jumper settings figured out, I can just adjust my "steps per mm" to make it come out correct?
Thank you all!