Hi,

I need 4

[www.thingiverse.com]

I'm assuming this works on 5/16" rods as well as 8mm rods - but a warning to anyone willing to print it for me, please check before you print as I have an SAE kit (although I do have M3/M4 parts I can use - so the holes/nut holders can be metric).

Can anyone print these for me?

Thanks in advance!

Ian

5/16" is 7.9375mm - I doubt the delta will make any difference, especially since you are clamping on a thread.

I'm willing to make these for you, what quantity do you need ?
I estimate the price I'd ask around 1.5 euros per clamp - not including shipping.

Do you have any preference for color ?
For material I'd recommend PLA as ABS would be softer against the thread, but that's up to you.

---

Most of my technical comments should be correct, but is THIS one ?
Anyway, as a rule of thumb, always double check what people write.