Welcome! Log In Create A New Profile

First Successful Print

Posted by tattooedfish

Forum List Message List New Topic

tattooedfish

First Successful Print
March 22, 2013 09:37PM

Registered: 11 years ago
Posts: 161

GUIDLER.jpg

I know its not much but im just excited that my prints are finally starting to turn out true and accurate this should help me with my issues of my filament wanting to print
This part is know as the guidler by greg Gregs Guidler / Extruder

Reply Quote

Greg Frost

Re: First Successful Print
March 23, 2013 08:50AM

Registered: 14 years ago
Posts: 486

Nice! I hope it works well for you. You know, most people don't seem to realise that there was an upgrade to the extruder body that went along with that that made observing and cleaning the Hobbed bolt easier (wider opening at the top of the extruder body).

Edited 1 time(s). Last edit at 03/23/2013 08:54AM by Greg Frost.

Reply Quote

tattooedfish

Re: First Successful Print
March 23, 2013 01:13PM

Registered: 11 years ago
Posts: 161

Greg Frost Wrote:
-------------------------------------------------------
> Nice! I hope it works well for you. You know, most
> people don't seem to realise that there was an
> upgrade to the extruder body that went along with
> that that made observing and cleaning the Hobbed
> bolt easier (wider opening at the top of the
> extruder body).

I did and I'm printing that next when I have time

Reply Quote

3ddude

Re: First Successful Print
March 24, 2013 09:43AM

Registered: 11 years ago
Posts: 106

Print is looking good! I've seen you've had a few issues getting to this point so well done for sticking it out. Well worth it thumbs up

Reply Quote

evan_calgary

Re: First Successful Print
March 27, 2013 10:47PM

Registered: 11 years ago
Posts: 12

Looks like a good start. I am in the process of building my printer and can't wait to get to that point!