Letters (bradley)
February 09, 2014 11:50AM
Just getting my Ormerod to full power, and as good workmate is leaving our team, wanted to do small present - his name.
So this is actually my first print (apart of calibration parts).

Did a bit of knife and sanding treatment to parts, as well "a" was first and did not fill well small details, but quickly adjusted that in slic3r so that rest of letters are well in-filled.

(sorry for mobile photo quality)

Edited 3 time(s). Last edit at 02/09/2014 11:56AM by moka.
Sorry, only registered users may post in this forum.

Click here to login