Welcome! Log In Create A New Profile

Stripping resolved

elwood127

Stripping resolved
September 11, 2016 02:36PM

Registered: 9 years ago
Posts: 705

Was having issues with stripping filament. My hob was misaligned per my drawing and new stepper shaft was flexing under pressure from the tensioner bearing. Redrew motor mount .030 forward and put old stepper back in. Not sure which was the culprit but prints like this were out of the question before. High retract prints were impossible. This too about 8 hrs. Back in the saddle again.

DSC00808.jpg

Reply Quote

deckingman

Re: Stripping resolved
September 11, 2016 03:27PM

Registered: 8 years ago
Posts: 622

Nice work! Not sure about the subject matter but that's a technically challenging print and you must have you printer pretty well dialled in to achieve that. Congrats.